Docs › Loops
Shell commands
Run a command in the loop's folder from its message box, and hand the agent what it printed.
Where Loop › Message box
1 min read
How it works
- Type
!first in an empty message box. It turns to Shell, and Enter runs what you type with your login shell, in the loop's folder or its worktree. - It runs at once, even while the agent works. A sheet on the page shows the command, the last lines it printed and how it ended, with the rest a press away.
- Once it ends, the agent is told what ran and what it printed, and answers. While the agent works, it is told when the turn ends.
- The stop tile on the sheet stops the command. One you stop goes to the agent with your next message.
Good to know
- Backspace on an empty line, or Esc, goes back to a message. ↑ and ↓ bring back the loop's earlier commands, and Shift+Enter starts a new line.
- A command has no terminal, so it cannot ask you anything. Use a terminal for one that does.
- The agent is given at most the last 12,000 characters of what was printed.